20-01-2013, 01:49 PM
for the front badge youll need to remove the badge and the plate behind it. You can not just filler this! You need to weld a plate across the gap as flush as possible. Then you need to apply filler and sand it down and respray it!
Remember if you debadge the bonnet youll also have to smooth the grille! TO do this ideally you need a donor grille to cut a section out of. Its then a matter of fibreglassing the donor section in the gap and filling it over again.
The problem with anything to do with filler really is the fact it an crack and ruin all your hard work. This is why you want to use as little filler as possible!
Its a bit of work so maybe have a go at painting the badge a different colour? Most people choose antracite? It looks different and is much easier to do!
Remember if you debadge the bonnet youll also have to smooth the grille! TO do this ideally you need a donor grille to cut a section out of. Its then a matter of fibreglassing the donor section in the gap and filling it over again.
The problem with anything to do with filler really is the fact it an crack and ruin all your hard work. This is why you want to use as little filler as possible!
Its a bit of work so maybe have a go at painting the badge a different colour? Most people choose antracite? It looks different and is much easier to do!