13-01-2013, 01:13 AM
(12-01-2013, 11:24 PM)Dan! Wrote: I had a tt/r32 arb. Gotta drop the subframe to fit it but only took me like an hour to do. Engine spacers are a bit of a lady garden to fit imo but 100% worth doing. 25mm takes the sump just higher than the subframe which means you can drive like a twat everywhere and not worry about your sump. Never got a scratch on mine. And chassis notch isnt too bad if you have a drill and a welder, just make sure its plenty big enough, I did mine a bit small first time round and had to re do it. :-)
You have/had the tabs on the coilies to attach them to? Reading up some people say that you have to and some people dont... half tempted to remove it altogether haha.
Plenty of 15mm spacers around so might give them a shot... seen a guide and said about removing expansion tank etc?
Might need to get a slightly less poweful welder as the arc we've got at the moment is a bit too beefy for most things haha.
Could well be asking you plenty more questions at this rate :p