12-01-2013, 07:55 PM
Timing has been double and treble checked, even rotated it 20 times and got all locking pins in, however the inlet cam pin is stiff going
but I cant imagine this stopping it from running, even if it would be a bit rough........ all sensors were fine before it was rebuilt but I shall
re check them.......
When timed up correctly all the pistons sat in line half way down the bores, is this normal??? a friend said maybe the crank pulley has moved
on the rubber, but I would have thought id just trash the valves if this was the case...... really am at a loss.............. can of easy start soon grrrrrrrrr
but I cant imagine this stopping it from running, even if it would be a bit rough........ all sensors were fine before it was rebuilt but I shall
re check them.......
When timed up correctly all the pistons sat in line half way down the bores, is this normal??? a friend said maybe the crank pulley has moved
on the rubber, but I would have thought id just trash the valves if this was the case...... really am at a loss.............. can of easy start soon grrrrrrrrr