06-12-2011, 11:43 AM
Switch colour LED Mod part 2
Passenger door switch
Turn switch over and push tabs in to release switch from bezel
take switch and push/lift tabs to release switch head
Note LED and resistor you are going to replace
turn switch to note the connections to the top board
take switch and gently hinge up top board to reveal the solder connections
Note direction the led is connected
unsolder the pads that the LED is soldered too
resolder new LED
carefully test the switch LED in the car for correct operation if the led does not light
unsolder the led ad reverse it then resolder
cut off component legs
gentely bend top board back making sure no connections touch the bottom board
reasemble switch
test in car
connection drawing for bench testing
Passenger door switch
Turn switch over and push tabs in to release switch from bezel
take switch and push/lift tabs to release switch head
Note LED and resistor you are going to replace
turn switch to note the connections to the top board
take switch and gently hinge up top board to reveal the solder connections
Note direction the led is connected
unsolder the pads that the LED is soldered too
resolder new LED
carefully test the switch LED in the car for correct operation if the led does not light
unsolder the led ad reverse it then resolder
cut off component legs
gentely bend top board back making sure no connections touch the bottom board
reasemble switch
test in car
connection drawing for bench testing