Oh, that could be an issue....my torque wrench only goes up to 300Nm...........will be ok to do to 300 and drive to the garage round the corner and ask if they'll just torque them up for us though I'd imagine?
Also, will have to see if sam's got a big enough socket then. My wrench is mains powered and claims to have 450Nm of torque......I guess that means it has the torque to remove anything less tight than that? So should be fine.
Got a part number for those white bushes?
And yeah will get some seals too...........as I lost half my gearbox oil from the 1.4 due to a faulty seal when the 'box was changed!!
I have done a clutch before, but only on a standalone engine, so quite a bit different from doing it on the car lol.
Will take a look at that guide then.....
Edit - My CS has run out so I cant see the guide over there.
Also, will have to see if sam's got a big enough socket then. My wrench is mains powered and claims to have 450Nm of torque......I guess that means it has the torque to remove anything less tight than that? So should be fine.
Got a part number for those white bushes?
And yeah will get some seals too...........as I lost half my gearbox oil from the 1.4 due to a faulty seal when the 'box was changed!!I have done a clutch before, but only on a standalone engine, so quite a bit different from doing it on the car lol.
Will take a look at that guide then.....
Edit - My CS has run out so I cant see the guide over there.