XUD exhaust question

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
XUD exhaust question
#1
Hey folks,

Got a 1997 Dturbo. Noticed that the CAT sits VERY close to the gear change rod, and so gives a wee clunk when the car is started and stopped. The exhaust will probably need renewed in the near future, and just wondering if I can simply change it for a non CAT type, this will be cheaper and easier to fit, and will remove the clunk too... Is this OK as I believe it is a visible smoke test only, or will the MOT guy know there should be a CAT based on VIN etc?
Reply
Thanks given by:
#2
Cat shouldnt be that close...sounds like bad fitment

Current regs say...if it had a cat...it needs one
Wishes for more power...
Reply
Thanks given by:
#3
(30-05-2016, 10:31 PM)Piggy Wrote: Cat shouldnt be that close...sounds like bad fitment

Current regs say...if it had a cat...it needs one

Hmmm. I did wonder why it was so close. Maybe I can drop it a bit by playing with the hangers. Looks like the CAT is welded into the pipe,no flange joins. Is this normal?
Reply
Thanks given by:
#4
Sounds like it's been messed with
Reply
Thanks given by:
#5
Change it for a decat and find an Mot tester that isn't an arse Smile
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Reply
Thanks given by:


Possibly Related Threads…
Thread Author Replies Views Last Post
  gt15 exhaust elbow question scottbmxer 0 1,055 18-04-2013, 04:41 PM
Last Post: scottbmxer

Forum Jump:


Users browsing this thread: 1 Guest(s)