27-02-2015, 06:04 PM
Hi All,
Done a few searches and can't find anything relevant so throwing a thread up.
I'm having issues programming my remote for the remote locking on kirsty's Ph1 XRDT. I have a known good remote circuit, (2 button from a Ph1 XRDT of the same year, so I'm assuming it should be the right type) which I have assembled in a new case with one of the blades from the car. Red light light's up when the buttons are pressed, but I can't seem to get it to pair with the car.
Could someone confirm the pairing procedure for me. From the 1996 owners manual I have the following:
Doors must be closed and not locked.
Use a key without the fob to turn the ignition to position 2 ("A" for accessories).
Touch the receiver (located close to the front courtesy light) with the remote control key, which should be held at between 5 and 10 degrees to the horizontal.
If the vehicle does not have a sunroof, bring the key in from the left-hand side.
If the vehicle does have a sunroof, bring the key in from the right-hand side.
Press the large button on the key until the LED is extinguished.
Turn off the ignition.
This sequence does not seem to work for me however :|
Could it be that the batteries in the key fob are no good but still have enough charge to light the LED? Alternatively, is there something wrong with the receiver/locking system/I have the wrong circuit?
Looking forwards to help!
Rich
Done a few searches and can't find anything relevant so throwing a thread up.
I'm having issues programming my remote for the remote locking on kirsty's Ph1 XRDT. I have a known good remote circuit, (2 button from a Ph1 XRDT of the same year, so I'm assuming it should be the right type) which I have assembled in a new case with one of the blades from the car. Red light light's up when the buttons are pressed, but I can't seem to get it to pair with the car.
Could someone confirm the pairing procedure for me. From the 1996 owners manual I have the following:
Doors must be closed and not locked.
Use a key without the fob to turn the ignition to position 2 ("A" for accessories).
Touch the receiver (located close to the front courtesy light) with the remote control key, which should be held at between 5 and 10 degrees to the horizontal.
If the vehicle does not have a sunroof, bring the key in from the left-hand side.
If the vehicle does have a sunroof, bring the key in from the right-hand side.
Press the large button on the key until the LED is extinguished.
Turn off the ignition.
This sequence does not seem to work for me however :|
Could it be that the batteries in the key fob are no good but still have enough charge to light the LED? Alternatively, is there something wrong with the receiver/locking system/I have the wrong circuit?
Looking forwards to help!
Rich