![]() |
Ph1 Remote Programming Issue - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22) +--- Forum: Electrics (https://www.306oc.co.uk/forum/forumdisplay.php?fid=23) +--- Thread: Ph1 Remote Programming Issue (/showthread.php?tid=29455) |
Ph1 Remote Programming Issue - RAW - 27-02-2015 Hi All, Done a few searches and can't find anything relevant so throwing a thread up. I'm having issues programming my remote for the remote locking on kirsty's Ph1 XRDT. I have a known good remote circuit, (2 button from a Ph1 XRDT of the same year, so I'm assuming it should be the right type) which I have assembled in a new case with one of the blades from the car. Red light light's up when the buttons are pressed, but I can't seem to get it to pair with the car. Could someone confirm the pairing procedure for me. From the 1996 owners manual I have the following: Doors must be closed and not locked. Use a key without the fob to turn the ignition to position 2 ("A" for accessories). Touch the receiver (located close to the front courtesy light) with the remote control key, which should be held at between 5 and 10 degrees to the horizontal. If the vehicle does not have a sunroof, bring the key in from the left-hand side. If the vehicle does have a sunroof, bring the key in from the right-hand side. Press the large button on the key until the LED is extinguished. Turn off the ignition. This sequence does not seem to work for me however :| Could it be that the batteries in the key fob are no good but still have enough charge to light the LED? Alternatively, is there something wrong with the receiver/locking system/I have the wrong circuit? Looking forwards to help! Rich RE: Ph1 Remote Programming Issue - RAW - 25-03-2015 Ok, so I diagnosed the issue with this. XRs it would seem don't get a full remote locking install. The sensor is there up in the courtesy light panel, but the wires get as far as behind the headlining before there is a multi plug with nothing connected to it :/ sometimes Peugeot just don't make any sense! Rich |