09-08-2014, 08:24 AM
Good work Tom
Rockers '6 Is back
|
09-08-2014, 08:24 AM
Good work Tom
09-08-2014, 09:27 AM
You'll wish you changed the gear oil seals while it was out of the car lol.... So much more difficult in situ!
But I'm glad you got it sorted and back on the road, nice one!
09-08-2014, 10:29 AM
Lol I bet it will be mate
Failed the mot this morning, needs a new balljoint, new cv boot, and handbrake needs adjusting Also got brake load sensing valve seized what's the best way of sorting this out?
09-08-2014, 12:26 PM
plus gas or wd40 the pivot pin and work it in til it frees up this is a common issue
09-08-2014, 05:10 PM
That's alright then now where can I find this pivot pin?
10-08-2014, 11:07 AM
26-08-2014, 09:51 AM
Finally!
Plenty of Bwaaappp now?
26-08-2014, 09:54 AM
Only been out with it once but it's nice to have the bwarp back
26-08-2014, 12:26 PM
Nice one dude, bet you're kind of glad it blew up now giving you the opportunity for so many new bits at once haha
Current stable
'09 Mercedes E320cdi wagon '99 306 gti6
26-08-2014, 12:28 PM
You could say that haha been an experience at least
26-08-2014, 02:27 PM
Good to hear she's back on the road.
28-09-2014, 09:58 PM
Great. Just f*cking great.
And no that's not my house
28-09-2014, 10:11 PM
(10-08-2014, 11:07 AM)Frosty Wrote: This is the brake load valve and the pivot pin is above where I'm pointing. Its pretty oblivious when you look at it in person Mine doesn't look like that, mines a r reg 6. (28-09-2014, 09:58 PM)rocker8742 Wrote: Great. Just f*cking great. You broke down?
#2 Moonstone Blue HDI
29-09-2014, 10:39 AM
blahhh what is with this car. What happened?
29-09-2014, 02:58 PM
Engine issues again
Was driving perfectly fine pulling well, went over a couple of speedbumps (not for the first time that night and the same ones) cruised along 3/4 mile at 25 ish up the road went to put my foot down and wouldn't pull at all Pulled up and it's hunting between 800 - 1k revs sounds like one of the cylinders has an issue doesn't appear to be any obvious air leaks Tried unplugging the lambda which made no difference Not too sure why it would suddenly drop off like that unless something's come unplugged Found that unplugged but can't find anywhere that it'd plug in
14-10-2014, 08:45 PM
That plug, I´ve seen thousands of people asking where the f@ck it goes, and answer is also the same, has no where to be plugged! Thats what i´ve found almost everywhere. Mine has that plug hanging there also. Might be for heated throttle body?
One question, im very interested in some things you have for sale, but cant post there, neither send mp. Can I just ask you here? To make things easier, i´d them to be shipped to Uruguay (of course is on me), but maybe you dont ship. Thanks
14-10-2014, 08:49 PM
Not sure if you have got this running properly yet but if not, start it up, get it to idle then unplug a coil at a time with it running. If you unplug one of them and it doesn't make any difference to how the car runs, that coil is dead
Team Eaton
1999 China Blue 306 GTi6 - Eaton Supercharged - 214.5bhp 181lbft
14-10-2014, 10:05 PM
(This post was last modified: 14-10-2014, 10:07 PM by rocker8742.)
(14-10-2014, 08:49 PM)Niall Wrote: Not sure if you have got this running properly yet but if not, start it up, get it to idle then unplug a coil at a time with it running. If you unplug one of them and it doesn't make any difference to how the car runs, that coil is dead Did manage to sort it in the end mate the MAP sensor was faulty, swapped it with another I had and its back running smoothly again having more issues with the diesel at the mo lol (14-10-2014, 08:45 PM)osm2121 Wrote: That plug, I´ve seen thousands of people asking where the f@ck it goes, and answer is also the same, has no where to be plugged! Thats what i´ve found almost everywhere. Mine has that plug hanging there also. Might be for heated throttle body? What bits were you after? Wouldn't have a clue how much it would cost to ship anything out there though
14-10-2014, 10:49 PM
(14-10-2014, 10:05 PM)rocker8742 Wrote: What bits were you after? Wouldn't have a clue how much it would cost to ship anything out there thoughMainly im after this 2: - Bare gti inlet manifold £5 - Gti throttle body with good sensors £5 And depending on shipping, this also: - 2x Gti cam cover and one blue one black coilpack cover £10 Could you get a shipping quote for the manifold + Throttle body? And the cam covers apart? Thanks mate
28-10-2014, 10:01 PM
Ok, after the Bare gti inlet manifold and the cam covers only, I´ve just seen the throttle body is sold. If you could tell me the weight, of manifold and covers I can check at ParcelMonkey for a quote. Im really interested!
Thanks
28-10-2014, 10:07 PM
F*ck sorry mate I completely forgot about this lol will try and get you a weight ASAP have you got an email address as it makes contact a bit easier
12-11-2014, 12:21 PM
Oh! Didnt see this. Osm2121@gmail.com
12-11-2014, 03:50 PM
Please can you sum up what has happened over the last few months?
I seem to remember the engine coming out at one point??? Daily Slag: http://306oc.co.uk/forum/thread-3849.html
Track Slag: http://306oc.co.uk/forum/thread-8873.html
12-11-2014, 04:09 PM
Lol went to combe heater matrix pipe came off and blew the head
Got it recovered home and bought a new lower mileage engine off dangti6 Fitted it and a load of new parts Mot'd and been running nicely since
13-11-2014, 12:20 AM
Went out in style then
New parts, as in a secret supercharger? Or boring standard parts? Daily Slag: http://306oc.co.uk/forum/thread-3849.html
Track Slag: http://306oc.co.uk/forum/thread-8873.html |
« Next Oldest | Next Newest »
|
Possibly Related Threads… | |||||
Thread | Author | Replies | Views | Last Post | |
Rockers '6 | rocker8742 | 56 | 20,405 |
18-11-2017, 08:42 PM Last Post: rocker8742 |