Oil catch can?

[MIKE-FORD]

Just been given one, any good for a hdi?

[madmadmax]

if its got 25mm ports on it then yes if not then no

[Piggy]

Bit pointless unless you are going for other upgrades.

Port size is a bit irrelevant tbh, just buy adapters/squeeze pipe on

[MIKE-FORD]

It's free so and dunno what port size is

[underground375]

[attachment=15068]


Fitted mine to the side of the battery casing in the old Xs I had.

[tigerstyle]

Port size is a bit irrelevant tbh, just buy adapters/squeeze pipe on

I've read that catch cans with small diameter ports can do more harm than good by not flowing the gas through freely enough? I can't quite believe the ports would be small enough to build up pressure, but however neglected over time it's a possibility...

[Poodle]

As above, there's been a few issues with people blowing the contents out all over the road, not that Piggy would know anything about that...

[Piggy]

I don't believe HDis suffer with such pressure issues as the XUD...plus on a standard map/turbo it wont cause much issue.

99% of cheap oil catch cans are roughly the same size and be up to the job

[Wolverine1091]

I've also got a catch tank kicking around doing sod all.

Anyone with a HDI fitted one? Can't really find a suitable place really.

[ash23]

ive just made one with big ports for my xud nice and cheap bodge xud style

[dr_jekyll]

Ive got a catch tank im about to fit, steps down from 25mm to 15mm and ran fine on my old car. Used it when i deleted the oil breather from the inlet to keep things clean. Worst case scenario is you'll blow your dipstick out but if you do that your engines heavily breathing

---

P.s im hdi