karl1989 black ph1 boost bus roof opinions

[Piggy]

with yellow fogs, you need the yellow lensed S16 twin optic lights I have for sale

---

[karl1989]

What are the brackets like? How much are they?

[Piggy]

yhpm

[Sambarker]

I've got some of those yellow twin optics spare

[karl1989]

May be breaking this now. Went to jack the ph1 up on the rear on the jacking point and the jacking point bent. So side skirt of and abit of tapping around and pulling brought this. Haven't tried rest if sill yet. Should I break or keep?

   
   
   
   
   
   
   
   

[Piggy]

if thats only place on whole car...keep it.

I dont think you will find a phase1 now without rust somewhere.
check from chassis legs.
front floorpan
rear arches.
if they all fine. just repair what you've found

---

front not from

[karl1989]

Rear arches are solid

[Tyronnster]

Gutted for ya

[Piggy]

Gutted for ya

Its only in one place!

an hours work with a plate, welder and some underseal and it be fine!!!

If the rear arches are solid, and the front chassis rails too, I would be fixing it for sure!!

[karl1989]

There is a hole at re front on drivers side. Look at pictures on first page

[Jonny81191]

Fix it. This is going to be more commonplace now, and if people just break or scrap at the first signs of rust, there's going to be a point where they become super rare. As piggy said, it's not all that hard to fix, underseal while you're at it.

[306Dan]

Just get a mig out and some plate and fix it, couple of hours work on both the sill and the front and you'll be right

[karl1989]

Took the old man up to see sill he said he seen a lot worse and it's repairable. Going to drop tank and get a new sill and sort it . Ph win project is back on

[306Dan]

glad to here it

[Jonny81191]

Good lad!

Have fun welding upside down!

[ozonehostile]

same place as the rust on my rallye. also looking forward to welding it lol

[karl1989]

Well got some bits to make it a proper ph1 thanks to danny and Jenk. Bumper, grill, bonnet, s16 steering wheel and boot plastics

   

Front bumper just pushed on for now

   

[Danny2009]

Looks better already!

[karl1989]

Got a few more bits cheers to Sam. Black bonnet, grill, morettes and wind deflectors. Will get pics later when fitted

[karl1989]

Few bits lve got done wile trying to sort out the other . Have got to pull my finger out now as I need to get this ready

   
   
   
   

[Piggy]

you wrapping the roof?? if so, what with?

[karl1989]

Ye mate. Carbon

[Alee83]

Looking much better already Karl...!

[karl1989]

Car is now in for welding. Been in since this afternoon so should be done tomorrow. Tank is out so and rear is ready to be welded up . Few pics of course

Front inner wheel arch

   
   

Finished

   
   

[devils_fuel]

Good job done mate bet your very happy

I need to find a good but cheaper welder in Bristol

[Danny2009]

well done for saving it lad looks like a top quality repair

[karl1989]

Ye I'm glad cheers guys . Hard finding a cheap welder especially a good one

[martyn92]

Thats a really good repair

[karl1989]

I'm really happy with it. Will upload more pics of the rest jacking points tomorrow

[Jenkosowls]

Get some stone chip on it ASAP will save a hell of allot of greif in the future. When's the plan for this to be on the road?