Karls XUD project

[padge]

Mate finished this today..





Few teething issuses but it boosts 22psi and thats with a massive leak, starts boosting at 3k! Standard 9mm pump with ground lda.

Thught i would start one of these for my mate, he isnt a member of any forum but he does linger about like a bad smell.

[padge]

Just clicked on, it looks EXACTLY the same as a GT20 found on the 1.8T rovers!

[Dan!]

Just out of interest, why didnt he keep it down the back?

[padge]

think he was bored?

[darrenjlobb]

Its a bit hard to see in the pics, but it looks like hes got the stock recird valve connected to the boost compensator / boost gauge :S

That part on the compressor housing isnt a boost outlet if thats what he thinks it is.... Its a built in bov by the looks of it, might be wrong but thats what it looks like...In which case, he is currently not getting a correct feed, but must be getting boost gauge readings, so not sure whats going on there lol!

[padge]

You are correct darren, i forgot why he's done that but its only temp, he needed the car for work today, hes got a brand new forge actuator on there too!

[Flynn]

Quite interested in the custom exhaust manifold. I want to get one, did he get it fabricated especially?

[padge]

No he did it himself, nothing fancy.