my d turbo s

[squarepants]

here's a few of mine, need to get the front lowerd. and sort the roughness out.

[Ben]

Deffinatly needs the front lowered! And possibly back raised?

[Mattcheese31]

dragging it's arse like a shitting dog . . . . . . . welcome to the club mate

[squarepants]

speed boating ftw lol

[the milkman]

Done anything engine wise to this pal?

[squarepants]

Done anything engine wise to this pal?

not yet. fitted a small k&n filter lol. it did have a letter box backbox on but i soon removed that! gonna make a straight pipe for the backbox and remove the centre box. also gonna turn the pump up but i need a boost gauge first.

it might have been done tbh, at some point in its life it's had a dump valve fitted and removed again as some one has cut the intercooler pipe and fitted abit of stainless piping in there where dump valves are normally fitted to these.

[puglove]

Defo needs the back raising atouch and the front dropping, either that or you need to slamm the front to match the back, but on those wheels you run the chance of it looking extreamly irish,

Also do you find it handles like a bag of shit with the rear that much lower than the front?

[the milkman]

Ahh get a front mount kit and slap that on few of us guys round the area will give you a hand if you like

[squarepants]

Defo needs the back raising atouch and the front dropping, either that or you need to slamm the front to match the back, but on those wheels you run the chance of it looking extreamly irish,

Also do you find it handles like a bag of shit with the rear that much lower than the front?

yeh front should match. from my experiance with 106's i reckon 60mm on the back handles better than 30.

Ahh get a front mount kit and slap that on few of us guys round the area will give you a hand if you like

yeh a front mount is on the cards, where abouts are you from mate?

[the milkman]

Ashton-u-lyne mate just over the hill like 20mins if that

[squarepants]

Ashton-u-lyne mate just over the hill like 20mins if that

34 miles apprently lol. i never even knew where ashton-u-lyne was haha. i'am bakewell side aswell so should take around 20minutes yeh

[the milkman]

hahaha well there you go not far

[jonny1.6]

dont touch the back imo but bring the front down to match and and it will look pretty sweet on the harriers you planning much power wise?

[Matt]

Irish spec FTL. Raise it up a tad and it will be spot on. My xsi was abit lower than that, handled like a bag of shite until it was raised up abit.

[Will_306_hdi]

Nice car abit low imo but max respect look sweet with front to match

[squarepants]

dont touch the back imo but bring the front down to match and and it will look pretty sweet on the harriers you planning much power wise?

thats the plan erm, gonna change the exhaust, turn boost up & more than likey a front mount at some point.

Irish spec FTL. Raise it up a tad and it will be spot on. My xsi was abit lower than that, handled like a bag of shite until it was raised up abit.

whats irish spec mean?

Nice car abit low imo but max respect look sweet with front to match

cheers mate. its a nice spec with it beeing an ''S'' but its rough bodywork wise lol. so i wouldnt say nice haha.

[Mattcheese31]

Irish spec basically means on the bumpstops mate lol, too low for 95% of us . .

[squarepants]

Irish spec basically means on the bumpstops mate lol, too low for 95% of us . .

its not on the bump stops, its 2 notch 60mm. 3 notch is when there on the bump stops thats like 90mm

[jonny1.6]

funny was just thinking yours was the same hieght as mine and only 2 notchs probley just looks lowerer at the back because its not at the front 60mm is a nice hieght to have a 306 imo

[Mattcheese31]

Irish spec basically means on the bumpstops mate lol, too low for 95% of us . .

its not on the bump stops, its 2 notch 60mm. 3 notch is when there on the bump stops thats like 90mm

looks more than 60mm to me mate tbh . . hey ho whatever you like .

[puglove]

IMO it looks feckin awfull at that hight especially on harriers that have no offset, but each to their own and all that, it would be boring if we all liked the same thing

[squarepants]

got some 60mm springs, also brought a hub with abs from the scrappy as my bearing has gone, so will get the lot fitted monday night/tuesday day if all goes well and weather is good

also got a 206 gti chrome gear knob, much better than my base model plastic one. also found some slightley smoked side repeters aswell. same tint as the rear lights so not chavvy dark smoke lol...

side skirts, splitter and a drivers side wing to replace my dented one next on the cards!

[Eeyore]

raise the back and lower the front. Get some decent wheels and then itll be good! :0

[squarepants]

i like d turbo wheels lol. i dont like cyclones, and nimrods are to expensive as are gti 180 wheels

[the milkman]

raise the back and lower the front. Get some decent wheels and then itll be good! :0

leave harriers alone! theres nothing wrong with them