Login

**Niall** · 21-06-2014, 12:58 PM

[Image: auto-part-ball-joint-for-peugeot-306-good-quality.jpg]

Right that is a 306 balljoint. The bit with the 3 holes sits inside the end of the wishbone. You want to measure from one of them bolt holes to the ball joint pin its self. I bet you will find that the one on the side your having troubles with is shorter than the other side. If so, replace the ball joint (only about £15 from ECP) with one for a PAS car.

**Nathan1305** · 21-06-2014, 01:09 PM

(21-06-2014, 12:58 PM)Niall Wrote:

Right that is a 306 balljoint. The bit with the 3 holes sits inside the end of the wishbone. You want to measure from one of them bolt holes to the ball joint pin its self. I bet you will find that the one on the side your having troubles with is shorter than the other side. If so, replace the ball joint (only about £15 from ECP) with one for a PAS car.

Awesome thanks Niall Smile

so I wanna measure from the centre of the hole to the centre of the ball joint pin like this?

[attachment=17003]

**Niall** · 21-06-2014, 01:41 PM

yeah can do. you will have to remove the ball joint from the hub to dp that so you could just measure both from one of the bolts to a point on the back of the hub

**Nathan1305** · (This post was last modified: 21-06-2014, 04:44 PM by Nathan1305.)

(21-06-2014, 01:41 PM)Niall Wrote: yeah can do. you will have to remove the ball joint from the hub to dp that so you could just measure both from one of the bolts to a point on the back of the hub

Yeah that way will be easier so measure from the bolt to the hub

Login
Username:
Password:	Lost Password?
	Remember me