18-12-2012, 11:46 PM
all of the manifold nuts came out with ease except for one haha and its rounded off whats the best way of getting it off
any help please[/u]
any help please[/u]
|
exhaust manifold nuts
|
 
19-12-2012, 12:20 AM
main problem is the space, or lack off, normally stud extractor, but i doubt you'll get a drill up there, could try a air cut off tool, or a dremel rotary tool type deal with a flexible end? short of heating it up loads with oxyacetaline torch and then getting a pair of mole grips on the nut
19-12-2012, 07:34 AM
Alot if heat and a socket thats slightly too small or a hammer and chisel. They're copper nuts so pretty soft. If not you'll happily fit a nut splitter up there.
19-12-2012, 07:36 AM
Mole grips probably your best bet mate.
Welding and fabrication projects undertaken, contact me for more information.
|
|
« Next Oldest | Next Newest »
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Exhaust Manifold Pressure gauge install | HDIkyle | 19 | 7,460 |
30-06-2015, 08:51 AM Last Post: mr_fish |
|
| Exhaust and inlet manifold spacers and studs | andyyy | 1 | 1,355 |
15-03-2015, 01:51 AM Last Post: zx_volcane |
|
| Exhaust manifold flange | anto | 15 | 4,488 |
04-03-2014, 12:15 PM Last Post: anto |
|
Users browsing this thread: 1 Guest(s)