Login

**Piggy** · 19-05-2018, 10:34 PM

Anyone know off hand the size in mm of the turbo outlet on a 2.0 HDi?

45mm comes to mind...?

**Poodle** · 21-05-2018, 05:45 AM

I thought it was smaller than that, 43 or maybe even 41mm. Try the intercooler guide threads, pretty sure at least one of those specifies.

Midnightclub · 21-05-2018, 08:57 AM

41mm sounds correct

Uberderv · 21-05-2018, 02:12 PM

I've got the original black rubber connector in the shed, will measure the ID later if you still need it.

**Piggy** · (This post was last modified: 22-05-2018, 05:17 AM by Piggy.)

(21-05-2018, 05:45 AM)Poodle Wrote: I thought it was smaller than that, 43 or maybe even 41mm. Try the intercooler guide threads, pretty sure at least one of those specifies.

Tried those,it just says to get the c5/406 bottom pipe.... Which I don't want to do...

(21-05-2018, 02:12 PM)Uberderv Wrote: I've got the original black rubber connector in the shed, will measure the ID later if you still need it.

That be amazing

Uberderv · (This post was last modified: 22-05-2018, 05:46 PM by Uberderv.)

Not been to the shed but this may help Smile

Filename: Screenshot_20180522-182414_Opera.jpg Size: 159.68 KB 22-05-2018, 05:26 PM

Sorry lol looking at No3. Will go shed Smile

42/43 mm3. Taken from a slightly squished section of hose (No1)

**Piggy** · 22-05-2018, 07:46 PM

Nice one... So you'd say 42mm would be a nice tight fit

Uberderv · 22-05-2018, 10:11 PM

Yeah should be, a good clamp round it too. As we know access behind there is very limited.

**Poodle** · 23-05-2018, 06:02 AM

Well the joiner joins the bottom pipe to the compressor outlet, so if it says 41mm that means it fits both, ie the turbo too.

Login
Username:
Password:	Lost Password?
	Remember me

Possibly Related Threads…
Thread		Author	Replies	Views	Last Post
	turbo outlet flange to make custom down pipe	pro_steve	5	2,366	25-06-2015, 11:26 PM Last Post: HDi--Power
	Turbo Inlet Size on 1999 HDI?	JTaylor2005	4	1,551	01-12-2014, 12:42 PM Last Post: JTaylor2005