+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: DW10 HDi section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=10)
+--- Thread: Turbo outlet size (/showthread.php?tid=36843)
Turbo outlet size - Piggy - 19-05-2018
Anyone know off hand the size in mm of the turbo outlet on a 2.0 HDi?
45mm comes to mind...?
RE: Turbo outlet size - Poodle - 21-05-2018
I thought it was smaller than that, 43 or maybe even 41mm. Try the intercooler guide threads, pretty sure at least one of those specifies.
RE: Turbo outlet size - Midnightclub - 21-05-2018
41mm sounds correct
RE: Turbo outlet size - Uberderv - 21-05-2018
I've got the original black rubber connector in the shed, will measure the ID later if you still need it.
RE: Turbo outlet size - Piggy - 22-05-2018
(21-05-2018, 05:45 AM)Poodle Wrote: I thought it was smaller than that, 43 or maybe even 41mm. Try the intercooler guide threads, pretty sure at least one of those specifies.
Tried those,it just says to get the c5/406 bottom pipe.... Which I don't want to do...
(21-05-2018, 02:12 PM)Uberderv Wrote: I've got the original black rubber connector in the shed, will measure the ID later if you still need it.
That be amazing
RE: Turbo outlet size - Uberderv - 22-05-2018
Not been to the shed but this may help
Sorry lol looking at No3. Will go shed
42/43 mm3. Taken from a slightly squished section of hose (No1)
RE: Turbo outlet size - Piggy - 22-05-2018
Nice one... So you'd say 42mm would be a nice tight fit
RE: Turbo outlet size - Uberderv - 22-05-2018
Yeah should be, a good clamp round it too. As we know access behind there is very limited.
RE: Turbo outlet size - Poodle - 23-05-2018
Well the joiner joins the bottom pipe to the compressor outlet, so if it says 41mm that means it fits both, ie the turbo too.