Remove amour from Bosch pump

[mickwha]

Any idea's?

Wanting to increase the fuel and thanks to this forum and some very helpful guys on here I know how. However my Bosch pump has amour on it and needs removed so I can get to the max fuel screw.

Anyone done this without removing the pump from the engine???

[Mattcheese31]

ermmmmmmm . . .

[Tom]

That allen bolt there looks something to do with it?

Is this in a 306? I didnt think any boschs had armour :/

[Mattcheese31]

is that deffo a Bosch? . . .

[mickwha]

That allen bolt there looks something to do with it?

Is this in a 306? I didnt think any boschs had armour :/

No it's a Fiat ducato 1.9td. Think it stops thieves getting to the stop solinoid. Either way it's stopping me from going faster....

[daddyfixit]

cdn2.newsok.biz/cache/w620-aeecc44ddaf0d5be0a54d19398b255f7.jpg

its not actually a 306, but there must be something I can turn........

[Mal]

Some of these pumps have the bolt heads filled in, a right bastard to get off if that's the case.... Lots of stainless steel cutting discs required! You may aswell change the distributor head when going that far :p

That's a pump off job if they're filled!

[Jiffy]

I de-armoured a Bosch pump from a 406 and it wasn't too bad but I couldn't have done it on the car. I hammered the security bolts loose with punches and a hammer. The last one was surrounded by armour though so I had to break out the angle grinder to get access to it.