+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: Remove amour from Bosch pump (/showthread.php?tid=14324)
Remove amour from Bosch pump - mickwha - 01-06-2013
Any idea's?
Wanting to increase the fuel and thanks to this forum and some very helpful guys on here I know how. However my Bosch pump has amour on it and needs removed so I can get to the max fuel screw.
Anyone done this without removing the pump from the engine???
RE: Remove amour from Bosch pump - Mattcheese31 - 01-06-2013
ermmmmmmm . . .
RE: Remove amour from Bosch pump - Tom - 01-06-2013
That allen bolt there looks something to do with it?
Is this in a 306? I didnt think any boschs had armour :/
RE: Remove amour from Bosch pump - Mattcheese31 - 01-06-2013
is that deffo a Bosch? . . .
RE: Remove amour from Bosch pump - mickwha - 01-06-2013
(01-06-2013, 06:42 PM)Tom Wrote: That allen bolt there looks something to do with it?
Is this in a 306? I didnt think any boschs had armour :/
No it's a Fiat ducato 1.9td. Think it stops thieves getting to the stop solinoid. Either way it's stopping me from going faster....
RE: Remove amour from Bosch pump - daddyfixit - 01-06-2013
cdn2.newsok.biz/cache/w620-aeecc44ddaf0d5be0a54d19398b255f7.jpg
its not actually a 306, but there must be something I can turn........
RE: Remove amour from Bosch pump - Mal - 01-06-2013
Some of these pumps have the bolt heads filled in, a right bastard to get off if that's the case.... Lots of stainless steel cutting discs required! You may aswell change the distributor head when going that far :p
That's a pump off job if they're filled!
RE: Remove amour from Bosch pump - Jiffy - 11-06-2013
I de-armoured a Bosch pump from a 406 and it wasn't too bad but I couldn't have done it on the car. I hammered the security bolts loose with punches and a hammer. The last one was surrounded by armour though so I had to break out the angle grinder to get access to it.