3mm spacer need longer bolts ? - Printable Version +- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum) +-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22) +--- Forum: Suspension, Transmission, Handling & Braking (https://www.306oc.co.uk/forum/forumdisplay.php?fid=19) +--- Thread: 3mm spacer need longer bolts ? (/showthread.php?tid=36769)

3mm spacer need longer bolts ? - carlukepeugeot - 22-04-2018 Hi folks Was thinking of putting 3mm spacers on the back to just give  a smidge more clearance between the back of the tyre and the wheelarch liner. Axle is still pretty good, not much camber but I just went from 14"  harriers to 15" cyclones on 195's and there's not much room there, especially as I fitted a phase 3 liner on the nearside (it's a  phase 2 car which didn't come with one on that side) - the liner fits well but bulges a little. Just wondered if I am likely to need longer bolts with just a 3mm on there?  Bolts are all new and are as below. I'll check their protrusion through the wheel. Rule of thumb 1.5 x diameter ?