+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: DW10 HDi section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=10)
+--- Thread: Any one got a hdi engine lying around? (/showthread.php?tid=33399)
Any one got a hdi engine lying around? - Paul_13 - 01-03-2016
I need a measurement of how far the head hangs over the block
Just for turbo clearance really down the back
RE: Any one got a hdi engine lying around? - bashbarnard - 01-03-2016
what do you mean overhangs the block? ive got one sitting in my current project that i need to whip out at some point soon. im sure i can get whatever measurements you need man
RE: Any one got a hdi engine lying around? - Paul_13 - 01-03-2016
The head is wider back to front than the block.
The head sits 20mm or so proud off the block.
Just trying to Gauge how much room I've got for an actuator
RE: Any one got a hdi engine lying around? - Poodle - 02-03-2016
I'll try and remember to check the one sat in the garage tomorrow.
RE: Any one got a hdi engine lying around? - Paul_13 - 02-03-2016
If you could and grab a fewpics pretty please.
My plate will be here for the adapter, Try not to f*ck this one up
RE: Any one got a hdi engine lying around? - Piggy - 03-03-2016
Due to the casting... The overhang varies.
27mm on that very first edge...but generally about 22mm from the flange for exhaust to the block edge
RE: Any one got a hdi engine lying around? - Paul_13 - 03-03-2016
Spot on. Repped
RE: Any one got a hdi engine lying around? - Paul_13 - 03-03-2016
Gives me a nice amount of room to fit an actuator on
RE: Any one got a hdi engine lying around? - Poodle - 03-03-2016
Mint, one less thing to do.
