+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: Xud to hdi clutch. Flywheel question. (/showthread.php?tid=30817)
Xud to hdi clutch. Flywheel question. - bashbarnard - 11-06-2015
So im putting Lus motor on the ramp soon to do the clutch and turbo. I have a good clutch from a hdi along with all bits. Inc cable. Is the flywheel sensor the same pickup? Or will we loose the rev counter. If so can I combat this somehow??
RE: Xud to hdi clutch. Flywheel question. - Seb_Ryan - 11-06-2015
Im pretty sure rev counter pickup is different
RE: Xud to hdi clutch. Flywheel question. - bashbarnard - 11-06-2015
Shit. Any chance of using the xud flywheel then??
RE: Xud to hdi clutch. Flywheel question. - xudlingo - 11-06-2015
From my experience hdi sensor on top gearbox like most petrol crank sensors and xud on back block. I have a 180 flywheel with push clutch on ma van. but had to grind off tabs on fly till only 2 left so rev counter would work lol
RE: Xud to hdi clutch. Flywheel question. - bashbarnard - 11-06-2015
Well ill have to get them side by side and compare.
RE: Xud to hdi clutch. Flywheel question. - Chairchild - 11-06-2015
HDi flywheel is something like 38-2 toothed setup, XUD is just a simple 4 tooth affair
If using an angle grinder to remove the teeth - be sure that you don't get the flywheel hot, just "tickle" the metal slowly, to reduce heat buildup.