+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: XUD Section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=11)
+--- Thread: T2 wastegate arm (/showthread.php?tid=26416)
T2 wastegate arm - AdamInNi - 01-09-2014
Anybody any trick to get the waste gate arm of a T2 back onto the pin after screwing it? Seems to be a right nightmare!
RE: T2 wastegate arm - Seb_Ryan - 01-09-2014
I had a bit of a struggle years ago, included a pry bar and a smashed finger lol, easier to get a mbc
RE: T2 wastegate arm - ADV_93 - 01-09-2014
As said, just stick an MBC on it. Makes turning boost up so much easier.
As for getting the arm back on, if you pull it a little (from the actuator) you should be able to get it onto the wastegate pin.
RE: T2 wastegate arm - Jimbo - 01-09-2014
Only trouble with not tightening the wastegate arm is you will probably get slight wastegate creep when running high boost pressures with an mbc
RE: T2 wastegate arm - Dave - 02-09-2014
Get a pair of mole grips around it and lever against the mole grips.