+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: 306 Repairs & Mods (https://www.306oc.co.uk/forum/forumdisplay.php?fid=22)
+--- Forum: Suspension, Transmission, Handling & Braking (https://www.306oc.co.uk/forum/forumdisplay.php?fid=19)
+--- Thread: Wheel hubs (/showthread.php?tid=24375)
Wheel hubs - BenDturbo1 - 31-05-2014
Upgrading all to gti6 parts looking for new steering knuckles (i think there called) which go behind wheel hubs and the front arm ball joints slide into them, so if anyone knows a site that sells them or would I have to go to a peugeot dealer?
RE: Wheel hubs - BenDturbo1 - 01-06-2014
Anyone know? :p
Wheel hubs - Frosty - 01-06-2014
Bit confused which part you are on about
RE: Wheel hubs - BenDturbo1 - 01-06-2014
Or is it called a hub carrier? Bit confused as to what it's called aswell! It's the actual bit where you slide the balljoint in and tighten up the pinch bolt
RE: Wheel hubs - Jonny81191 - 01-06-2014
You'd need gti hubs mate, they're a compete cast unit
RE: Wheel hubs - BenDturbo1 - 01-06-2014
http://www.carparts4less.co.uk/cp4l/c/Peugeot_306_2.0_1999/p/car-parts/car-transmission/transmission-parts/wheel-bearing-and-wheel-hub/?629540020&1&6101d5589ebbdade9f8fd35a56f4d96dbb3df8a1&000602
Do you know where i could get a complete cast unit dude? as this isnt the complete unit is it
RE: Wheel hubs - cully - 01-06-2014
think the hubs are std across the range other than bearing diameter and bottom ball joint hole size
gti hubs are 82mm dia bearings and could be 16mm or 18mm balljoints
some other modles are 72mm with 16mm or 18mm balljoints
RE: Wheel hubs - Jonny81191 - 01-06-2014
(01-06-2014, 08:56 AM)BenDturbo1 Wrote: http://www.carparts4less.co.uk/cp4l/c/Peugeot_306_2.0_1999/p/car-parts/car-transmission/transmission-parts/wheel-bearing-and-wheel-hub/?629540020&1&6101d5589ebbdade9f8fd35a56f4d96dbb3df8a1&000602
Do you know where i could get a complete cast unit dude? as this isnt the complete unit is it
For complete units, go second hand and clean them up, then drop in some bearings and new hub faces like the one you linked. As Cully says, they're standard across the range other than the bottom balljoints.