306oc - Peugeot 306 Owners Club & Forum
Just to clarify heater matrix? - Printable Version

+- 306oc - Peugeot 306 Owners Club & Forum (https://www.306oc.co.uk/forum)
+-- Forum: Engines (https://www.306oc.co.uk/forum/forumdisplay.php?fid=16)
+--- Forum: DW10 HDi section (https://www.306oc.co.uk/forum/forumdisplay.php?fid=10)
+--- Thread: Just to clarify heater matrix? (/showthread.php?tid=22073)



Just to clarify heater matrix? - Dodgy Bob - 10-03-2014

So last week did a coolant flush and boy did it need it, all was good until yesterday. Footwell carpets are damp both sides and it's pink so it's deffo coolant, found some drips down the boot that goes over the steering column. Is there any other thing it could be? Obv I'm just trying to avoid removing the whole dash but everything in the engine bay looks dry-ish. I'd rather not rad weld my new coolant is there anything else I can check or anywhere else I can look before ripping out the dash?


RE: Just to clarify heater matrix? - Mattcheese31 - 10-03-2014

Could be where the matrix joins through the bulkhead, other than that get stripping the dash out mate, if you need any advice give me a shout, I've just done it Smile


RE: Just to clarify heater matrix? - Dodgy Bob - 10-03-2014

Seems unavoidable doesn't it?!?! I got 4 days off coming up next week so will have to do it then. ECP list only one matrix for a BEHR system is that the right one?


Just to clarify heater matrix? - rocker8742 - 11-03-2014

Sounds like exactly what I had, matrix wasn't sealing where it joined the pipes through the bulkhead

The BEHR matrix is the one for ac I think


RE: Just to clarify heater matrix? - Toms306 - 11-03-2014

Yup behr is ac, valeo is non ac. Smile