Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How To - 2.1TD Swap / XUD11 Fitting
#69
(09-12-2014, 10:32 PM)Piggy Wrote: I can do some measurements for you but bear in mind that the engine may sit differently and be mounted at a different point on the engine to yours

Yeah well about that I keep asking myself about something: there is a picture on the thread I took where it shows the holes of right side of the bloc. Is there this very same holes (in same position) in the XUD9TE and XUD11?

(09-12-2014, 10:28 PM)Dum-Dum Wrote: I can't check engine height as i sold mine

Don't worry about the ECU, run it on a bosch fuel pump and you'll be fine. I put mine in a car that ran modern ECU high pressure direct injection and it was fine with that removed, just needed different clocks and a couple of alterations to the loom.


Edit: obviously I've never worked on a toyota so can't promise this.

Course but something keeps bodering me: my car uses a mass air flow meter while the XUD9TE and XUD11 (as far as I know) have only air temperature sensor. How will I manage this? I just put the same mass air flow meter on the admission of the XUD11 and hope the ECU makes no diference or just remove it and exchange it for a simple temperature sensor?
Reply
Thanks given by:


Messages In This Thread
How To - 2.1TD Swap / XUD11 Fitting - by Dum-Dum - 03-12-2012, 10:14 PM
RE: How To - 2.1TD Swap / XUD11 Fitting - by Ben - 04-12-2012, 09:28 AM
RE: How To - 2.1TD Swap / XUD11 Fitting - by Ruan - 08-12-2012, 08:24 PM
RE: How To - 2.1TD Swap / XUD11 Fitting - by Orta - 20-06-2014, 09:34 PM
RE: How To - 2.1TD Swap / XUD11 Fitting - by machsantos - 09-12-2014, 11:45 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  lower height pistons xud11 of 1 mm niciou 3 5,182 01-03-2018, 07:44 PM
Last Post: niciou
Wink The judge and its xud11 Sambo the bodger 37 14,235 24-06-2017, 06:04 AM
Last Post: bashbarnard
  Turbo relocation xud11 and 1.4 hdi bits Sambo the bodger 7 4,706 04-02-2017, 08:24 AM
Last Post: Dum-Dum

Forum Jump:


Users browsing this thread: 3 Guest(s)