The Racetractor. The End.

[Piggy]

so bonnet is here if I hadnt already said, still wrapped up till next week when i have time to start cutting holes in it. Then paint it. I was going to get kellets to paint it but after talking to me best mate who paints carbon n Fg stuff on lambos etc, he said its SO difficult to get a flat finish on FG/carbon bits that a rattle can finish would probably be as good. So we shall see. Hope I have enough paint to do the front bumper and rear o/s quater panel ding. Hoping too that Dumdum has me a better rear bumper to save painting that!

Driveshaft is here also...ready to go on tomorrow at some point.

And new radiator is here...I am a magpie to shiny things...

[attachment=23858]

So dug out loads of spare coolant pipe for the bottom second and a quick shopping spree on ebay for 30mm connectors, a 30mm/18mm T piece (to plumb in the heat exchanger), 8mm barbed screw in connector (for the stat housing bleed off), a bunch of jubilees and a new fan fitting kit (SO MUCH thicker!).... all to make it fit. 

Probably need to reroute the boost pipe, but I got some bits to do that hopefully left over. 

And I need a expansion tank, which I will use a old ph2/3 one for now and then get one made that is also nice n shiny!

Hope to have a mocal plate and longer lines too coming soon...will try and fit that just in front of washer bottle to keep air flow uninterrupted to the rad.

Once we get all this done...I think its weighbridge time again!