Using DMNs base coding/map.
Lots of fine tuning/adpating and calibrating to do mind.
Not much to show other than a poorly back from being bent over the engine bay for 3hours sorting the loom. Cut out the stuff I never and dont ever need. Retaped, insulated and fresh conduit here and there to tidy it all up.
Started to see where the water feeds and N75/vaccuum pipes will be going. Going to be one busy engine bay!!
Also, sorted my braided oil line. Its a bit long but it cost me 10.49 plus about a fiver of diesel!! Haha, eat that Puggy!
I now have every little bit needed to do the job
Just the putting it together... Hmmm
Lots of fine tuning/adpating and calibrating to do mind.
Not much to show other than a poorly back from being bent over the engine bay for 3hours sorting the loom. Cut out the stuff I never and dont ever need. Retaped, insulated and fresh conduit here and there to tidy it all up.
Started to see where the water feeds and N75/vaccuum pipes will be going. Going to be one busy engine bay!!
Also, sorted my braided oil line. Its a bit long but it cost me 10.49 plus about a fiver of diesel!! Haha, eat that Puggy!
I now have every little bit needed to do the job
Just the putting it together... Hmmm
Wishes for more power...