28-09-2012, 01:28 PM
(This post was last modified: 28-09-2012, 02:45 PM by zx_volcane.)
never mind, just drilled a hole in the case and tapped it out
Best place to tap for IPP
|
28-09-2012, 01:28 PM
(This post was last modified: 28-09-2012, 02:45 PM by zx_volcane.)
never mind, just drilled a hole in the case and tapped it out
28-09-2012, 03:32 PM
was going to say you can get a fitting used when plumbing into a test bench thats what ive got from local derv specialist cost £2 and guage screw straight in
28-09-2012, 03:52 PM
Lol, the wonders of knowledge eh?
I've tapped a 1/8 bsp and going to run hose to gauge in dash, prefer to do it the awkward non oem way, with added swarf bonus
28-09-2012, 04:03 PM
Your pump still on the car?!
This is what I did with the pipe/gauge, although I had the pump off/half strimmed to remove the swarf that falls out into the pump!
28-09-2012, 04:13 PM
(This post was last modified: 28-09-2012, 04:15 PM by zx_volcane.)
(28-09-2012, 04:03 PM)Dave Wrote: Your pump still on the car?! Good God no, its in a million little pieces on the bench (aka the kitchen table). Spare pump I'm modding / building up at a snails pace, but prob all good to go back together now and see if it works! I'm just paranoid swarf has found its way into some little orifice |
« Next Oldest | Next Newest »
|