hi spec 4 pots again

[Pompey306mark]

http://www.ebay.co.uk/itm/Hi-Spec-Motors...2a1f7c0e35

[Scott]

It may just be me, but for 285mm discs it hardly seems worth it. I'd rather spend the money on a new set of discs and 1144s or DS2500s

[puglove]

Thanks mark will be watching as they are just up the road from me could i use my drilled and grooved gti discs with these?

[Pompey306mark]

You can use these with 6 discs. And these stop much better than and 6 set up I have had.

[puglove]

Cool. Ima keep an eye on it. What pads would you recomed for these?

Also is the master cylinder man enough for these?

[Pompey306mark]

I have used Mintex 1144 and 1155 I will post a link for them on camskill later as on mobile now.

Anyone who has been in my car will know how good these are.

[Ben Jay]

i've heard these stop lock ups....

[puglove]

Cool thanks. Will have a little look around later as im on my phone aswell lol. Quite like the sound of these . Just hope i can get them under cyclones with a resonable spacer.

IIRC dint you run a 10mm on cyclones? Was there any arch mods?

[Pompey306mark]

I did have 10mm and cyclones. Not arch work. You could always roll the lip if you need a bit of space.

[puglove]

Didnt really want to do that either , take it you didnt then?

[Pompey306mark]

http://www.camskill.co.uk/m33b0s3403p277...rake_Pads_

Na the fronts I did for the borbets