06-10-2021, 10:28 PM
(This post was last modified: 06-10-2021, 10:38 PM by pug306driver.)
Might you have any idea of the wiring for the stop light switch ?
Is there a relay involved at all ?
There seems to be 4 wires going to the switch, a 2 terminal switch, on or off. There are 2 pairs of wires, the pair of wires joining at the switch terminal block.
Tomorrow I am going to cut the wires, join each seperate pair and make an extension to make fitting the terminal to the switch easier, then I can isolate the switch and test, even hot wire to test the switch and the wiring to the lights under load, completely independent from the car wiring, that way I will know the switch and wiring from it to the lbrake lights are ok.
Hoping it's just a switch problem rather than a fault deeper in the cars loom etc..
A proper accurate wiring diagram would be good, the Haynes wiring diagram is crap.
Is there a relay involved at all ?
There seems to be 4 wires going to the switch, a 2 terminal switch, on or off. There are 2 pairs of wires, the pair of wires joining at the switch terminal block.
Tomorrow I am going to cut the wires, join each seperate pair and make an extension to make fitting the terminal to the switch easier, then I can isolate the switch and test, even hot wire to test the switch and the wiring to the lights under load, completely independent from the car wiring, that way I will know the switch and wiring from it to the lbrake lights are ok.
Hoping it's just a switch problem rather than a fault deeper in the cars loom etc..
A proper accurate wiring diagram would be good, the Haynes wiring diagram is crap.
