01-11-2018, 09:45 AM
(This post was last modified: 01-11-2018, 09:46 AM by pug306driver.)
Cant remember if the n/s/front drive shaft has the central? support bearing or not, but the shafts entering the diff are "sprung loaded" into place rather than held in via a snap ring, I may be wrong, if I am please someone confirm?
Is the in out play "springy" ? ie held in place via spring action.
When the arm was off and re fitted, the larger bolt holding the arb bush clamp is involved with the p bush. Is the arb bush clamp in properly?
I remember i had some fun when refitting the arms, using a g clamp to hold down the arb bush clamp so i could get the larger bolt and nut in place etc..
You sure the knock is not steering rack related ?
Is the in out play "springy" ? ie held in place via spring action.
When the arm was off and re fitted, the larger bolt holding the arb bush clamp is involved with the p bush. Is the arb bush clamp in properly?
I remember i had some fun when refitting the arms, using a g clamp to hold down the arb bush clamp so i could get the larger bolt and nut in place etc..
You sure the knock is not steering rack related ?