Hi, I found a few guides related to rear axle rebuilds/ lowering but jpgs are dead links and opera wont play the videos.
I can see there are a lot of complications with the rear axle, so would someone help out with the diagnostic of my right rear wheel sagging? It appears to be approx 25mm further in to the wheel well than the left side, that is all I have observed, looks straight etc.
Car (XUD) has done 56000K now, could it be as simple as adjusting the torsion bar, but seen mention you must withdraw from splines on both sides first, not to mention collapsed beam etc so am confused at this stage.
I'm travelling North Queensland at the moment, may be a day or two before I get back to the forum.
TIA Ron
I can see there are a lot of complications with the rear axle, so would someone help out with the diagnostic of my right rear wheel sagging? It appears to be approx 25mm further in to the wheel well than the left side, that is all I have observed, looks straight etc.
Car (XUD) has done 56000K now, could it be as simple as adjusting the torsion bar, but seen mention you must withdraw from splines on both sides first, not to mention collapsed beam etc so am confused at this stage.
I'm travelling North Queensland at the moment, may be a day or two before I get back to the forum.
TIA Ron