306oc - Peugeot 306 Owners Club & Forum › Engines › DW10 HDi section v
Cut a hole in the inner wing to get at the belt tensioner?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cut a hole in the inner wing to get at the belt tensioner?
cheapo Offline
Active Member
Posts: 98
Threads: 15
Joined: Sep 2015
Reputation: 0
Location: Exeter
Car Model/Spec: '99 306 2.0 HDI GLX
Thanks: 1
Given 0 thank(s) in 0 post(s)
#3
02-03-2018, 09:06 PM
(02-03-2018, 05:46 PM)Poodle Wrote: You know you can get to it through the wheel arch if you remove the top engine mount and lower the block slightly, right..?

Hmm, I'm sure you're right. And when it comes down to it I'll have the engine resting on a trolley jack already to install a new belt. So, jack up, jack down, jack off, it's all one. (unless my back's out again, then it'll have to to my favourite garage for the job)
But I just liked the idea of cutting a big f-off hole in there and re-covering it with Tupperware or something. Tongue
WoW! That was cheap!  Inlove
Find
Reply
Thanks given by:


Messages In This Thread
RE: Cut a hole in the inner wing to get at the belt tensioner? - by cheapo - 02-03-2018, 09:06 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Trouble changing Auxillary belt - automatic tensioner CaptainHair 10 2,604 12-01-2019, 10:38 AM
Last Post: pug306driver
  flywheel locking hole pug306driver 26 4,586 28-08-2015, 11:33 AM
Last Post: tigerstyle
  Hole in cylinder head, very wet floor.. dieselgeek 12 2,336 15-11-2014, 06:01 PM
Last Post: dieselgeek

Forum Jump:


Users browsing this thread: 1 Guest(s)