11-01-2020, 07:23 PM
Got the correct pads, both sides done inside an hour and a ten minute job adjusting the handbrake.
Couldn't get anywhere near the lambda sensor to change it, and there was no join after the cat that I could take off that section to do it on the bench. I did however find a small crack just after the cat where it was cut and welded which had now split slightly, and the cat was rubbing on the subframe (explains how boomy the exhaust has become) got a temporary fix on this!
Retest day today, and barring a telling-off from the tester who seemed very snotty for some reason, we have another years test!
Sent from my ONEPLUS A5000 using Tapatalk
Couldn't get anywhere near the lambda sensor to change it, and there was no join after the cat that I could take off that section to do it on the bench. I did however find a small crack just after the cat where it was cut and welded which had now split slightly, and the cat was rubbing on the subframe (explains how boomy the exhaust has become) got a temporary fix on this!
Retest day today, and barring a telling-off from the tester who seemed very snotty for some reason, we have another years test!
Sent from my ONEPLUS A5000 using Tapatalk