So theres a fair bit of surface rust under the boot floor on the 306, some parts fine some with bad surface rust, looking at wire brushing then sanding and using Hammerite Kurust and then painting over in silver then snading down again if necessary then another coat of pain(same colour as the car), has anyone used Kurust?
I know most people use deox gel and a good few other products but I don't fancy spending that much, however it does not look that much more expensive, what would people advise on a budget?
Any thoughts and opinions appreciated.
Cheers guys.
I know most people use deox gel and a good few other products but I don't fancy spending that much, however it does not look that much more expensive, what would people advise on a budget?
Any thoughts and opinions appreciated.
Cheers guys.