Anyone running Pug 307 266mm Brakes?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Anyone running Pug 307 266mm Brakes?
#1
Well if you are, snap these Brembo Max Discs up quickly, remember these will NOT fit standard 266mm Peugeot 306 Brakes, only calipers from the 307 or if you have a 307 with 266mm front brakes! (I know, bit of a long shot but someone gets a bargain hopefully)

http://www.amazon.co.uk/Brembo-09-8695-7...-0&sr=1-10


Look on the right and select the "USED" discs, while it says it is used, most likely it's just the box that is damaged. I bought a pair of 283mm and the discs were brand new, the box was only slightly damaged in the corner!


P.s, you can check your cars fitment here:

http://www.bremboaftermarket.com/En/Car_...Mode=Model
Reply
Thanks given by:
#2
Nice find, they deffo no good for 306 266's then?
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Reply
Thanks given by:
#3
Definitely no good, the part numbers don't match up Sad
Reply
Thanks given by:
#4
Stiffer calipers and 10mm more disc offset on the 307's, that's what I ran on mine.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Reply
Thanks given by:


Forum Jump:


Users browsing this thread: 1 Guest(s)