Posts: 211
Threads: 42
Joined: Jan 2014
Reputation:
2
Thanks: 0
Given 0 thank(s) in 0 post(s)
Fitting xud9 engine into a s reg peugeot partner
Can you use the original peugeot partner driveshafts and clutch cable etc?
Is it pretty much a straight forward swap?
Any tips / advice would be appreciated
Posts: 278
Threads: 36
Joined: Nov 2014
Reputation:
4
Location: Falkirk scotland
Car Model/Spec: Berlingo xud / 306 gti6
Thanks: 5
Given 6 thank(s) in 6 post(s)
You need to change clutch cable partners is push clutch and turbo ones are pull
The shafts are ok bur on mine I had to change inner joint going in to box for short shaft
Mine was face lift so even more changes had to be done
Posts: 211
Threads: 42
Joined: Jan 2014
Reputation:
2
Thanks: 0
Given 0 thank(s) in 0 post(s)
So you used 306 inner joint onto the normal van driveshaft ? Could I just use a whole 306 passenger shaft ?
Posts: 3,539
Threads: 42
Joined: Mar 2012
Reputation:
28
Thanks: 3
Given 89 thank(s) in 88 post(s)
405 shafts arent longer by much at all, if at all.
some are the same part number.
Posts: 182
Threads: 6
Joined: Jun 2015
Reputation:
0
Location: Earby Bb186xh
Car Model/Spec: 306 hid 3 door
Thanks: 0
Given 0 thank(s) in 0 post(s)
On a similar subject my dad has my old 53 plate partner van it's got the 1.9d wd8 engine which I find it under powered and revy a specialty on motorway but I'm yours to my hdi 306 is it possible to fit longer rasho gearbox like the 306 and also if We get it remapped bit more power or is they a better way