Posts: 38
Threads: 2
Joined: Jan 2015
Location: Rotherham
Thanks: 0
Given 1 thank(s) in 1 post(s)
Country:
what should the standard VE pump be set to, when using a DTI to measure lift, at TDC?
Every bloody source gives a different value, from 0.5mm, all the way up to 1.54mm?? We've set it to 0.8mm, but it would be nice to know the *actual* figure, rather than just guessing...
Anyone know?
Posts: 3,662
Threads: 127
Joined: Feb 2012
Reputation:
33
Location: London
Car Model/Spec: ZX Volcane TD
Thanks: 6
Given 31 thank(s) in 31 post(s)
In my experience, just time it up by ear on the slots, should be plenty good enough
Only time I went to the trouble of setting it up with a DTI with a book figure (haynes maybe?) it was way out :/
Posts: 1,748
Threads: 41
Joined: Dec 2011
Reputation:
12
Location: Midlands
Car Model/Spec: Dtractor
Thanks: 0
Given 6 thank(s) in 6 post(s)
Yeh as said, time it so it sounds lively and you have a small amount of clatter as you rev it stationary. Its better to have too much than not enough, make too much smoke/melt turbos in extreme cases. I used to run my on elongated slots at maximum but I had a load dependant pump with the matal pipe coming out the front bottom centre of the pump.
![[Image: avatar_zpstlcgvhg8.jpg]](http://img.photobucket.com/albums/v363/toastmonster/avatar_zpstlcgvhg8.jpg){kind=avatar}
![[Image: 22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg]](http://i585.photobucket.com/albums/ss299/Ha11elujaz0rs/22f2b6b2-758b-4c1c-96fb-6fa9c6059b13_zpsf306b56b.jpg)