engine mount replacing

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
engine mount replacing
#1
Hi how easy is it to replace the engine mounts as I think mine might have gone as I have got a lot of feed back through my pedals whilst driving, my gear stick has the usual shaking problem and most of the time when I pull away from being stationary it judders when I let the clutch out.

Is it easy to replace them if they need replacing or will i need a hoist.
Reply
Thanks given by:
#2
Could all be done with a trolley jack, relatively easy really.
Doesnt even own a 306.
Reply
Thanks given by:
#3
(01-04-2014, 04:59 PM)Tom Wrote: Could all be done with a trolley jack, relatively easy really.


Great news as I'm limited with space and tools. Thanks also how many are there I know of the one at top left as you look at the engine and one underneath.
Reply
Thanks given by:
#4
Three mounts in total - upper engine mount (drivers side top), gearbox mount (passenger side under battery) and lower rear engine mount.

The only one that's a bit of a pain to change is the lower rear mount, as you need to remove the driveshaft for that which in turn means draining the gearbox oil. Not difficult, just a little time consuming.

Worth checking the condition of the shell where the upper mount screws in as there is often cracks or it broken away entirely. Noticeable knocking or cracking noises as you come on and off the power are a giveaway.
1990 Peugeot 205 GTi 1.9 // 1991 Peugeot 205 GTi 1.9 16v // 1992 Peugeot 205 GTi 1.9 // 1999 Peugeot 306 HDi Estate
Reply
Thanks given by:
#5
Let me know how you get on as I think mine are fubarred
[Image: siggy1.jpg]

the smokey old bus that sounds like a tractor...
Reply
Thanks given by:
#6
I heard a knocking noise from drivers side, when i turn or speed up in 1st gear..
Reply
Thanks given by:
#7
(10-04-2014, 04:18 PM)jonas306 Wrote: I heard a knocking noise from drivers side, when i turn or speed up in 1st gear..
I thought knocking noise when you turn could be drive shaft, not sure. A
s for my car its going I'm selling it for around £300 possible head gasket failure.
Reply
Thanks given by:
#8
(10-04-2014, 04:23 PM)dadaddy35 Wrote:
(10-04-2014, 04:18 PM)jonas306 Wrote: I heard a knocking noise from drivers side, when i turn or speed up in 1st gear..
I thought knocking noise when you turn could be drive shaft, not sure. A
s for my car its going I'm selling it for around £300 possible head gasket failure.

But it;s a low knocking noise, and it's in low curve, if i'm parking for example don't hear anything..
Reply
Thanks given by:


Possibly Related Threads…
Thread Author Replies Views Last Post
  Top rubber engine mount Pearcey1995 2 1,009 01-06-2015, 06:46 AM
Last Post: gregpurdie16
  Facelift berlingo d turbo rear engine mount problems Jamieh2013 7 2,290 12-05-2015, 05:01 PM
Last Post: Jonny81191
  Rear engine mount help ADV_93 3 1,060 29-07-2014, 06:03 PM
Last Post: ADV_93

Forum Jump:


Users browsing this thread: 1 Guest(s)