Yorkshire RR Day Results!

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Yorkshire RR Day Results!
#61
I dont understand how your car danny with them mods pulled such a low power even more so when your over 30psi? Confused

But once you sort it should be a right animal! Such a nice car! But if you do lose the love feel free to sell me them wheels Tongue



Reply
Thanks given by:
#62
Quick question about these figures?
Are they Bhp or hp? since my car was 160ps as standard new which translates to 158 (B?)hp

On the graphs it's written as engine power:146hp and Wheel power 120hp. Does this mean I've lost 15bhp or 38bhp or did I never have 160bhp and it was 160hp and after drivetrain losses it was more like 135bhp?
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
#63
PS is pointless, it just makes cars look a bit more powerful written down lol.

So yeah you should've had ~158bhp at the engine to start with. Obviously you lose ~15bhp or so through the drivetrain so wheel power will be less. So basically, assuming your car left the factory with 158bhp, you've only lost 12bhp......
Reply
Thanks given by:
#64
You might not have lost it, quite often manufacturers figures are done without the belt driving the water pump/PAS and alternator on
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Reply
Thanks given by:
#65
(13-10-2013, 06:17 PM)Chris_90 Wrote: I dont understand how your car danny with them mods pulled such a low power even more so when your over 30psi? Confused

But once you sort it should be a right animal! Such a nice car! But if you do lose the love feel free to sell me them wheels Tongue

Burned to clean and vey quickly because the lda pin wasn't even engaging till the last cm or so on throttle arm travel. Ie it wasn't adding more fuel when it needed it top end was running lean on boost
Perv 106 1.4 xs First Pug Love - Scrapped
Perv 306 1.6 5 Door Hore - Sold
110bhp 207 Hdi Sport - Used as a Brake
173bhp T25 Ph1 Diablo Dturbo - Scrapped
Thirsty Bitch Volvo 850 Estate - Sold
51bhp Berlingo Nad DT Van - Sold
Slow as f*ck Dispatch Work Horse

www.prestige-auto-care.co.uk
Reply
Thanks given by:
#66
So Danny was the one that bought those minilites from will the other month, snapped them up quick! Looks like some decent results there, I would like to attend the next one if it's not too far away, I only live up the road from zx too so if I could keep up with him lol I would follow him
[Image: attachment.php?aid=9919]
Reply
Thanks given by:
#67
(13-10-2013, 08:26 PM)lolsteve Wrote: Quick question about these figures?
Are they Bhp or hp? since my car was 160ps as standard new which translates to 158 (B?)hp

On the graphs it's written as engine power:146hp and Wheel power 120hp. Does this mean I've lost 15bhp or 38bhp or did I never have 160bhp and it was 160hp and after drivetrain losses it was more like 135bhp?

Manufacturers figures are always at the flywheel mate, 135bhp at the wheels is probably about what you had new, for the first 3k until the first HG blew Wink
[Image: tapatalk_1427020983519_zpsnwvozlhb.jpeg]
Reply
Thanks given by:
#68
(13-10-2013, 09:12 PM)Jenkosowls Wrote:
(13-10-2013, 06:17 PM)Chris_90 Wrote: I dont understand how your car danny with them mods pulled such a low power even more so when your over 30psi? Confused

But once you sort it should be a right animal! Such a nice car! But if you do lose the love feel free to sell me them wheels Tongue

Burned to clean and vey quickly because the lda pin wasn't even engaging till the last cm or so on throttle arm travel. Ie it wasn't adding more fuel when it needed it top end was running lean on boost

oooooo So should be all good now then you fiddled with it, would love to see what it pulls once its sorted Smile



Reply
Thanks given by:
#69
Jenks seems to have sorted it just needs setting up properly now

Not drove it since Saturday ill get round to it eventually
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
Reply
Thanks given by:
#70
Blind running so couldn't guarantee Danny said it felt lol it pulled better but I personally couldn't say

Anyone get vid of my van on the dyno as my camera didn't record it!
Perv 106 1.4 xs First Pug Love - Scrapped
Perv 306 1.6 5 Door Hore - Sold
110bhp 207 Hdi Sport - Used as a Brake
173bhp T25 Ph1 Diablo Dturbo - Scrapped
Thirsty Bitch Volvo 850 Estate - Sold
51bhp Berlingo Nad DT Van - Sold
Slow as f*ck Dispatch Work Horse

www.prestige-auto-care.co.uk
Reply
Thanks given by:
#71
okay so it's not just rover conning me out of power, everyone does it Smile
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
#72
(14-10-2013, 11:59 AM)lolsteve Wrote: okay so it's not just rover conning me out of power, everyone does it Smile

Not everyone, but off the top of my head, Honda, Mazda, Rover did it and possibly still do, even aston and jag used to pull those tricks.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Reply
Thanks given by:
#73
(14-10-2013, 07:59 AM)THE_Liam Wrote: Manufacturers figures are always at the flywheel mate, 135bhp at the wheels is probably about what you had new, for the first 3k until the first HG blew Wink

so just confirming a gti6 is 167 at the flywheel then ?
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
#74
Yes. A healthy GTi-6, boggo stock would pull about 140hp at the wheels.

With an airfilter, an exhaust and intake cam advanced slightly mine ran 177hp @ the flywheel and 144hp at the wheels.
JP
Reply
Thanks given by:
#75
(14-10-2013, 12:52 PM)lolsteve Wrote:
(14-10-2013, 07:59 AM)THE_Liam Wrote: Manufacturers figures are always at the flywheel mate, 135bhp at the wheels is probably about what you had new, for the first 3k until the first HG blew Wink

so just confirming a gti6 is 167 at the flywheel then ?

should've just bought a 6 . . . Wink
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Reply
Thanks given by:
#76
and with the throttle bodies and mapped it did 205hp at the flywheel and 168hp at the wheels
JP
Reply
Thanks given by:
#77
Goodgood, was worried the gti was 167 at the wheel and im stuck at 135 kind of thing. project beat a gti6 is back in action Big Grin
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
#78
[Image: th_MyMovie1111_zpsd7600352.jpg]
[Image: 65613_10200761612710317_1548698655_n_zps68c27004.jpg]

CONVOI EXCEPTIONNEL
Reply
Thanks given by:
#79
Some awesome results there!

I'm surprised spellowe hasn't jumped in and started a bandwagon of some description?

Popcorn
Diablo Hdi Dturbo and 205 1.9 project - it lives!
Reply
Thanks given by:
#80
(14-10-2013, 10:01 AM)Jenkosowls Wrote: Blind running so couldn't guarantee Danny said it felt lol it pulled better but I personally couldn't say

Anyone get vid of my van on the dyno as my camera didn't record it!

There you go,One of the few vids I got. Spielberg I aint!

http://www.youtube.com/watch?v=9asbPtYG-...e=youtu.be
Team hand-painted-commercial Vehicle
Reply
Thanks given by:
#81
She really does whine lol!
Perv 106 1.4 xs First Pug Love - Scrapped
Perv 306 1.6 5 Door Hore - Sold
110bhp 207 Hdi Sport - Used as a Brake
173bhp T25 Ph1 Diablo Dturbo - Scrapped
Thirsty Bitch Volvo 850 Estate - Sold
51bhp Berlingo Nad DT Van - Sold
Slow as f*ck Dispatch Work Horse

www.prestige-auto-care.co.uk
Reply
Thanks given by:
#82
(14-10-2013, 08:28 PM)Jenkosowls Wrote: She really does whine lol!

So does the van :p
TD04 11mm Sedan, now 2.1 vnt

Sedan Project http://306oc.co.uk/forum/thread-5763.html

Provence Dturbo Dead
Blaze 1.6 Dead
China 5dr '6 Death by cambelt failure
Matt White HDI estate Death by wiring
Sedan Dturbo aka triggers broom
Diablo estate Dturbo Living dead
Reply
Thanks given by:
#83
they really need to use straps lol.
[Image: Untitled-1_zpsc57da38e.jpg]
Reply
Thanks given by:
#84
Jees. Did they not use any straps? No way I would put my car on there!!
JP
Reply
Thanks given by:
#85
Are there no vids of the 205 making a bid for freedom?
Reply
Thanks given by:
#86
Was it that bad Tom?
JP
Reply
Thanks given by:
#87
Yup... strapless. They just mount big lad on front end


S2 HDi >click<
154bhp
280lbs/ft
Reply
Thanks given by:
#88
i thought they strapped them down last time . . . .Undecided
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
Reply
Thanks given by:
#89
(15-10-2013, 08:21 AM)Arron Wrote: Yup... strapless. They just mount big lad on front end

Sometimes two Smile

Anyone get a vid of the zr doing it's thing?
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
#90
Think jenks did? I only got afew vids I'll upload the 205 tonight
Team hand-painted-commercial Vehicle
Reply
Thanks given by:


Possibly Related Threads…
Thread Author Replies Views Last Post
  Guess the BHP - Non 306 Content *Results Are In* PartyJas 43 10,036 06-07-2015, 10:08 AM
Last Post: PartyJas
  Interesting 'How Many Left' Results... Matt-Rallye 27 5,089 20-06-2015, 02:07 PM
Last Post: Kezzieboy
  MOT results.. cwspellowe 12 2,963 25-06-2013, 04:00 PM
Last Post: cwspellowe

Forum Jump:


Users browsing this thread: 1 Guest(s)