New turbo
306oc - Peugeot 306 Owners Club & Forum › Engines › XUD Section v
New turbo

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New turbo
David Offline
Previously Mowle5677
Posts: 1,498
Threads: 155
Joined: Dec 2011
Reputation: 11
Location: Norfolk/Wiltshire
Car Model/Spec: Bianca DTurbo
Thanks: 0
Given 0 thank(s) in 0 post(s)
#1
01-02-2013, 12:01 PM
So today me and Sam are fitting his brand new turbo and I know we have to prime it before starting it up for the first time but the real question is do we have to let it run in at certain psi before allowing it to boost more?
[Image: edit2_zpsbe60b3ca.jpg]

Team derv FLAME and CONROD spitters
Find
Reply
Thanks given by:
Ruan Offline
"Gearbox Side" towards engine 4 lyf

Registered users - Donated
Posts: 5,205
Threads: 91
Joined: Dec 2011
Reputation: 83
Location: Oxfordshire/Cornwall
Car Model/Spec: Moonstone DT/Volvo V50
Thanks: 2
Given 41 thank(s) in 41 post(s)
#2
01-02-2013, 12:11 PM
Just crank with the solenoid wire off for 10 seconds which will prime the turbo with oil, I'd personally stick to low boost for the first 20-30 miles or so, don't bother adjusting the wastegate, just don't shove your foot in it and hope everything will be fine, build up to full throttle and between bringing it on boost allow it to cool off so you know everything is OK...
(16-05-2016, 10:45 AM)Toms306 Wrote: Oh I don't care about the stripped threads lol, that's easily solved by hammering the bolt in. Wink
Nanstone GTD5 GT17S - XUD9TE
Volvo V50 D5 R-Design SE Sport - Daily cruise wagon.
Find
Reply
Thanks given by:
David Offline
Previously Mowle5677
Posts: 1,498
Threads: 155
Joined: Dec 2011
Reputation: 11
Location: Norfolk/Wiltshire
Car Model/Spec: Bianca DTurbo
Thanks: 0
Given 0 thank(s) in 0 post(s)
#3
01-02-2013, 12:34 PM
Just what I wanted to hear thanks
[Image: edit2_zpsbe60b3ca.jpg]

Team derv FLAME and CONROD spitters
Find
Reply
Thanks given by:


Forum Jump:


Users browsing this thread: 1 Guest(s)