Help with my ph3 converstion. (Pictures added)

[underground375]

Hi all after needing to grind my front end just to fit the ph3 slam panel ive now run into another problem.

The hockey sticks. Ive left my ph1 wings on thinking there the same as the ph3, but when I put the hockey sticks on I found they don't line up with the wings? I went out and got two new clips to fit them, but they sit to high and to far in?

Also the sides of the bumper sit a little to far in so the wing sits over the bumper. Is that related or a warped bumper?

Ive got a thing for lines not been straight so its really bugging me!!!


Heres a few pictures to try and show what im on about.

   

   

The left side sits more in then the rite side but they both sit to high for the wings.

Also ive just noticed this. Where the bumper don't line up with the wings also.

   

   

   

Would anyone have a picture of a ph3 wing? Maybe to take a picture where the hockey sticks fit to it?

[Pompey306mark]

Spacers on the bumper mount. To force the bumper out.

Cable tie the hockey sticks to the crystals.

[underground375]

I was thinking about cable ties, as ive spent enough getting this done without replacing both wings. =\

[ozonehostile]

have you got a phase 3 slam panel?

[underground375]

Yeah slam panel, grill hockey sticks, head lights, bumper, bonnet. Only thing I can think it may be is the wings are different, where the clips push into the wing. I no the holes for the bump strips don't line up also.