Wanted: 16" Dished wheels

[Maximus]

Anything deep dished really, not too keen on multispokes.

Cheers

[Birk]

Brock b1's 16x9" £450 with 3tyres, that's if Sam doesn't want them.

[Maximus]

Brock b1's 16x9" £450 with 3tyres, that's if Sam doesn't want them.

Any issues with fitting? I thought the limit was 8J?

They look great by the way...

[puglove]

yeah you will need to roll the archs. but you will with 8Js any way

[Birk]

Depends how low you go, but whats the point in wide wheels if you dont go low aye.

Also, it depends on the offset of a wheel as to where it sits in the arch, an 8" et 15 could fit fine, but then one with a 0 et could foul, you just never know until you work it out.

I had the brocks on two of my 306s, both had rolled arch's, which is easy enough to do, the estate had pulled front arch's and slightly flared on the rear, my 3dr had the same on the front with just the rear of the arch flared, but they where both very low.

Dan

[Maximus]

Depends how low you go, but whats the point in wide wheels if you dont go low aye.

Also, it depends on the offset of a wheel as to where it sits in the arch, an 8" et 15 could fit fine, but then one with a 0 et could foul, you just never know until you work it out.

I had the brocks on two of my 306s, both had rolled arch's, which is easy enough to do, the estate had pulled front arch's and slightly flared on the rear, my 3dr had the same on the front with just the rear of the arch flared, but they where both very low.

Dan

I do like them. Are you willing to accept any less than £450?

Where about are you from?

[Birk]

From Doncaster in Yorkshire.

Not wanting to go any lower tbh, I think £450 is good for such a rare wheel, I am supplying spacers and bolts as well and can offer delivery for £40

[Maximus]

From Doncaster in Yorkshire.

Not wanting to go any lower tbh, I think £450 is good for such a rare wheel, I am supplying spacers and bolts as well and can offer delivery for £40

No worries, I agree they are rare.