19-06-2013, 12:29 PM
chris_90 106 derv project xsi rep, turbo NAD ;)
|
19-06-2013, 12:49 PM
(19-06-2013, 12:29 PM)cwspellowe Wrote:(18-06-2013, 01:47 PM)Midnightclub Wrote: Speak to diggers, him and his brother did a 106 1.9dt conversion project Why's it a heap? not been looked after?
21-06-2013, 03:08 PM
Just a couple of pics from today nothing great but thought i would share
Thats chatsworth house in the back ground Comments welcome
21-06-2013, 08:44 PM
Looking nice for a 106. Not been chatsworth for ages.
#2 Moonstone Blue HDI
02-07-2013, 06:35 PM
03-07-2013, 08:23 AM
(02-07-2013, 06:35 PM)Pugmarshall Wrote:(18-06-2013, 12:45 PM)samass Wrote: f*ck the 1.9, supercharge the 1.5 I have been thinking this but i carnt find a cheap super charger Also i dont no much about superchargers but surely they carnt get up to as much psi as a turbo?
03-07-2013, 09:34 AM
Picked up a strut brace and leguna splitter yesterday. Fitted strut brace gave it a blow over in silver but nothing great as needs a propa strip back and paint but its there for function not for looks
Put splitter on scrapes on every bump So not sure how long it will last till it gets ripped off Plus im not sure if i like it or not so would like your opinions?? What you guys think? In other news im going down the turbo 1.5 route, picking up a t2 turbo of pugmarshall at pugfest gonna start collecting bits to get it done think it will be slow progress but will get it done eventually. Been e-mailing cg clutch people and they say they could custom make a 5 paddle clutch to take the extra power/toque for £250 so defo will be looking in to that once it is turbo'ed. Comments welcome
03-07-2013, 10:06 AM
kinda like it with and without . . .either way looking good fella . .
Phase 1 D-Turdo, K14@24 psi, De-cat, meaty backbox, Bosch pump, grinded LDA pin, duel air fed K&N =133.7bhp & 188ft/lbs
03-07-2013, 10:10 AM
I can't make my mind up about the splitter lol
What did cg say they could rate the clutch to hold? Torque wise I mean Member of the 99% warning or you're nothing club
03-07-2013, 10:25 AM
(03-07-2013, 10:10 AM)samass Wrote: I can't make my mind up about the splitter lol We'll I came up with some over the top figures told them I estimate it to be 150bhp and 240ftlbs of torque then they said they could custom make a 5 paddle clutch for it to hold that power/torque (03-07-2013, 09:58 AM)Matt Wrote: Splitter looks awesome (03-07-2013, 10:06 AM)Mattcheese31 Wrote: kinda like it with and without . . .either way looking good fella . . Thanks :-) not sure if I like it or not think unvented would look better, see how I get on with bumps might be ripped off tonight
03-07-2013, 02:38 PM
I reckon the splitter makes it look kinda busy at the front, i quite like the clean look it's got now.
03-07-2013, 03:27 PM
no splitter.
be watching this closely with the turbo route... the clutch is the weak point. shame it cost so much though. its why I still going down xud9 route with the mrs 106. 150bhp no worries for min money Wishes for more power...
03-07-2013, 04:09 PM
Nice, that should work nicely. I've got a second hand 4 paddle sprung clutch that used to be used on the cup cars, no idea what it's rated to tho, guess I'll find out when I get the new engine in lol
Member of the 99% warning or you're nothing club
03-07-2013, 04:20 PM
(19-06-2013, 12:29 PM)cwspellowe Wrote:(18-06-2013, 01:47 PM)Midnightclub Wrote: Speak to diggers, him and his brother did a 106 1.9dt conversion project where are you? last i heard it had gone to Edinburgh after the bloke broke the driveshaft. and id like to point out it was MINT wen it left us, try get a pic of it now, would be intresting to see what theyve done to it. last bloke said it had a full interier put back in so not sure what its like now. SOLD Dan! Wrote:Want me to blow this one up for you aswel?
03-07-2013, 06:12 PM
Looks the nuts with the splitter on! Leave it and put up with the scraping!
Member of the 99% warning or you're nothing club 2000 Moonstone 1.8 Meridian - Sold 2000 China 3dr XS - Dead 1998 Diablo 3dr XSI
03-07-2013, 07:29 PM
split decision on the splitter with you guys lol, Keeping it for now but i am unsure about it my self will see how i get on.
Gave it a clean and wax agin today looking well, just need to get tidying it up ready for pugfest wish i had a better interior but doubt i will get one in time
So bit of an update picked these billy bargains up yesterday im over the moon with them, There in near mint condtion apart from the slight cracking of the leather on the drivers seat no rips or tares. Any way pics
(there not marks on the center just the material goes different when you brush it the other way) So just gave them a good clean with the vax, sat on the back drying at the min might be in today if there dry in time should be in this sun. Just need to sort out some door cards so i can get rid of the horrid pattern. As for the leguna splitter its coming off asap its getting me to much attention every time i go near a bump scraps like fook every one is turning around lol so its going not sure when cos carnt be ased to lay under car hopefully a bump will rip it off for me save me doing it Comments welcome
05-07-2013, 10:17 AM
They're bloody compfy to! I put some of those in my saxo back when i was a chav haha Really nice seats though :p
Doesnt even own a 306.
05-07-2013, 11:54 AM
(05-07-2013, 10:17 AM)Tom Wrote: They're bloody compfy to! I put some of those in my saxo back when i was a chav haha Really nice seats though :p There not bad No chav about the seats tho There in the car no anyway sun dried them out in no time, smelling nice and fresh to make as change than the smell in side my car Quite like the bucket style of them cos now when i go round a corner i dont slide out my seat and head butt passenger side window So just need to sort dash out hoping to do that Sunday get rid of the crappy bits i painted before.
05-07-2013, 05:12 PM
You want a coin tray gear surround thing from a s2 now. And door cards.
Looking real smart dude.
05-07-2013, 05:56 PM
this is really coming together!
I personally prefer the front without the splitter
Diablo Hdi Dturbo and 205 1.9 project - it lives!
(05-07-2013, 05:12 PM)306carter Wrote: You want a coin tray gear surround thing from a s2 now. And door cards. Yer defo need one of them just for more storage (05-07-2013, 05:56 PM)ginge191 Wrote: this is really coming together! Splitter has gone took it off put it for sale 1 hour later some one come for it
05-07-2013, 07:38 PM
(05-07-2013, 06:17 PM)Chris_90 Wrote:(05-07-2013, 05:12 PM)306carter Wrote: You want a coin tray gear surround thing from a s2 now. And door cards. Where did you sell it and how much?
#2 Moonstone Blue HDI
05-07-2013, 09:01 PM
@Kent on the fb pages frog is the one it sold on but was most pages £10 I sold it for.
08-07-2013, 08:24 AM
Bit of an update really skint this month seen as im going to the two cars shows need to do some finshing touchs to the car needed to sort out the door cards AND.........
A few coats of paint (yes ordinary spray paint) and they looked like that not perfect but look loads better than they did before So just got a few other bits to sort before pugfest hopefully have it sorted in time Comments welcome
09-07-2013, 05:22 PM
Those seats are actually amazing! Looking great so far pal!
3 x Peugeot owner.
1996 106. 1996 306 D Turbo S. 1994 Mercedes Benz 320E. 1997 306 GLX. Subscribe! - https://www.youtube.com/user/TheADKJD/videos |
« Next Oldest | Next Newest »
|
Possibly Related Threads… | |||||
Thread | Author | Replies | Views | Last Post | |
Peugeot 309 d turbo project | adampug | 30 | 14,300 |
04-12-2016, 10:03 AM Last Post: adampug |
|
Chris_90's citroen zx volcane The END | Chris_90 | 309 | 94,677 |
29-09-2015, 09:00 PM Last Post: Chris_90 |
|
Project Facelift Berlingo D Turbo | Jamieh2013 | 11 | 6,010 |
21-03-2015, 05:01 PM Last Post: Jamieh2013 |
Users browsing this thread: 4 Guest(s)