|
GT2056 fitting q's
|
02-11-2012, 10:17 PM
(02-11-2012, 10:06 PM)cwspellowe Wrote: the problem for me is the actual centre bore, nothing to cut that out unless I go 100% pikey with an angle grinder! Drill lots of little holes in a cirle, then get happy with the file? Or drill a big ish hole and blow it out with the arc welder turned well up
Gov modded 11mm Bosch + Standard turbo = 137.2bhp . . . . TD04 now in...time to get playing!
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
GT2056 fitting q's - by cwspellowe - 01-11-2012, 10:10 PM
RE: GT2056 fitting q's - by Dave - 01-11-2012, 10:22 PM
RE: GT2056 fitting q's - by cwspellowe - 01-11-2012, 10:23 PM
RE: GT2056 fitting q's - by Jake - 01-11-2012, 11:22 PM
RE: GT2056 fitting q's - by padge - 01-11-2012, 11:50 PM
RE: GT2056 fitting q's - by Ruan - 02-11-2012, 08:46 AM
RE: GT2056 fitting q's - by zx_volcane - 02-11-2012, 09:12 AM
RE: GT2056 fitting q's - by cwspellowe - 02-11-2012, 10:06 PM
RE: GT2056 fitting q's - by zx_volcane - 02-11-2012, 10:11 PM
RE: GT2056 fitting q's - by cwspellowe - 02-11-2012, 10:12 PM
RE: GT2056 fitting q's - by Harky - 02-11-2012, 10:17 PM
RE: GT2056 fitting q's - by cwspellowe - 02-11-2012, 10:18 PM
RE: GT2056 fitting q's - by Harky - 02-11-2012, 10:46 PM
RE: GT2056 fitting q's - by zx_volcane - 02-11-2012, 10:48 PM
RE: GT2056 fitting q's - by cwspellowe - 02-11-2012, 10:58 PM
RE: GT2056 fitting q's - by Ruan - 03-11-2012, 07:01 PM
|
