24-04-2020, 10:53 PM
Recently converted a hdi 306 to a xud9 with a t2 turbo and Bosch pump but having a few problems
When it starts after about 10 turns there is alot of white smoke and sounds very lumpy and wont idle for more than a minute , if you keep pumping the primer it will idle no problem but still smoky, have an inline filter instead of the housing and always seems to be air in the filter and the air bubble gets bigger until it finally cuts out , would it not bleed itself after running for a few mins or do you have to extract all the air yourself? Tried advancing pump and it didn't make a difference.. checked timing and that's all 100%
Last conversion I done just seemed to work but this one not so much ?
When it starts after about 10 turns there is alot of white smoke and sounds very lumpy and wont idle for more than a minute , if you keep pumping the primer it will idle no problem but still smoky, have an inline filter instead of the housing and always seems to be air in the filter and the air bubble gets bigger until it finally cuts out , would it not bleed itself after running for a few mins or do you have to extract all the air yourself? Tried advancing pump and it didn't make a difference.. checked timing and that's all 100%
Last conversion I done just seemed to work but this one not so much ?