14-04-2020, 09:59 PM
This is the original fitting for the oil feed/drain, it had to be cut as it would never fit in the bay with the length of the pipes, anyone know what way I would go about fitting the lines to this? Im assuming if it was just clamped on by hose clamp the pressure would blow the pipes off?? Of would it be okay to fit it like that?? Any info on this would be appreciated!
On a better note, the turbo is looking [emoji7][emoji7] not sure about the position of the actuator yet... Im not sure if Ill have enough clearance, although I think its the only position ill be able to put it as it is now pushing on the turbo arm perfectly, unlessss.. I can make some kind of mechanism (I definitely don’t want to have to go down that road).
Sent from my iPhone using Tapatalk
On a better note, the turbo is looking [emoji7][emoji7] not sure about the position of the actuator yet... Im not sure if Ill have enough clearance, although I think its the only position ill be able to put it as it is now pushing on the turbo arm perfectly, unlessss.. I can make some kind of mechanism (I definitely don’t want to have to go down that road).
Sent from my iPhone using Tapatalk