15-01-2019, 09:28 PM
(This post was last modified: 15-01-2019, 09:31 PM by wainwrightj.)
(15-01-2019, 07:29 PM)Toms306 Wrote: No, pressure plate bolts don't need loctite. They're a very low torque setting as well.
Get a proper aligning tool if it's your first time...the pull type clutch is an arsenal to line up the box with the clutch fork as it is, don't make it more difficult with off centre splines lol.
Where would I get a cheap one from, it's not a job i'm planning on doing more than once so won't need to be anything special
Given the low torque settings is it worth buying a torque wrench to do the hub nuts instead of one suited for the clutch bolts? I've been quoted £250 labour for someone else to fit the clutch but by doing it myself I was planning on spending some of that money on a torque wrench to do this job and then others later on down the line?