26-11-2016, 06:56 PM
On my current 2.1 engine the rev counter is taken from the standard place on back of the block. However on the new bottom end i have built there is no holes to fit in the same place (currently has a larger flywheel with lugs on it where rev is taken from the top of gearbox)
How can i fit the sensor to allow rev clock to work using standard clock?
How can i fit the sensor to allow rev clock to work using standard clock?
TD04 11mm Sedan, now 2.1 vnt
Sedan Project http://306oc.co.uk/forum/thread-5763.html
Provence Dturbo Dead
Blaze 1.6 Dead
China 5dr '6 Death by cambelt failure
Matt White HDI estate Death by wiring
Sedan Dturbo aka triggers broom
Diablo estate Dturbo Living dead
Sedan Project http://306oc.co.uk/forum/thread-5763.html
Provence Dturbo Dead
Blaze 1.6 Dead
China 5dr '6 Death by cambelt failure
Matt White HDI estate Death by wiring
Sedan Dturbo aka triggers broom
Diablo estate Dturbo Living dead
